The standard FD range of gear couplings
will accommodate parallel offset, angular
misalignment and axial movement, or a
combination of all three.
1) The maximum speeds specified above are
generally based on the limit of the
lubricant being used. To attain these
speeds a separate balance operation may
be necessary depending on the
requirements of the application. Special
couplings can be supplied for higher
speeds or more sensitive applications.
2) Maximum bores specified are for
uniformly loaded drives only. See table 4
on page 3 for factors to apply when other
than uniform loads are applied.
3)All dimensions are subject to
confirmation. General arrangement
drawings are available which show
certified dimensions.
4)Puller holes can be supplied.
5). Hubs are available with longer boss
lengths.
6) Mass and Inertia are based on solid hubs.
All Inertia figures are MR². Multiply this
figure by 4 to obtain GD².
